Electrolux GOOD Service Manual page 24

3. Remove the front service panel from the washer.
Using two or more people, carefully lift the
washer onto the pedestal and set flush against
the rear brackets as shown.
NOTE: If washer was previously installed,
disconnect power cord, remove inlet hoses
from water faucets and tape the drain hose to
the top of the washer to eliminate excess
water on the floor. Also, make sure the
leveling legs are adjusted fully into the
washing machine.
4. Align the sides of the washer with the sides of
the pedestal and attach the washer to the rear
brackets using four #10 screws (2 per bracket).
5. Open the drawer of the pedestal; assemble a
carriage bolt through a front spacer and rubber washer.
6. Insert the bolt/spacer assembly up through the
pedestal with the front spacer positioned in the
square hole of the pedestal and the bolt coming
through the slotted hole in the washing machine
base.
7. Install a rubber washer, flat washer and hex nut
onto the carriage bolt. Tighten the hex nut.
24