Removing The Overflow/Vent Tube Grommet; Removing The Overflow/Vent Tube - Electrolux GOOD Service Manual

2. Using a small common screw driver, release the (8)
locking tabs around the water inlet tubes while
pushing on the grommet rim from inside the washer.

Removing the overflow/vent tube

grommet:
1. Disconnect the washer from the electrical supply,
remove the top panel and cut the thin wall joint
section between the water inlet and the overflow/vent
tube grommet.
2. Using a small common screw driver release the (3)
locking tabs around the overflow/vent tube while
pushing on the grommet rim from inside the washer.
Removing the overflow/vent tube:
1. Disconnect the washer from the electrical supply
remove the top panel and remove the overflow/vent
grommet.
2. Turn the tube counter clockwise about a 1/16 of a
turn to unlock the tube. Pull the tube back to
disengage it from the detergent dispenser housing.
3. Push the front of the tube down and forward toward
the water inlet valve assembly until the tube clears
the rear panel.
78