Drain Pump - Electrolux GOOD Service Manual

For water to enter the fabric softener channel, both the
left and right inlets must be activated. As the water from
the left inlet passes over the channel, it collides with the
water from the right inlet.
This collision changes the water path directing it to the
front of the cavity and into the fabric softener channel.
The fabric softener channel forms a loop, that allows the
water to pass over the fabric softener cavity section of
the drawer.
As the water passes over the fabric softener section,
holes in the cavity allows some of the water to enter and
mix with the fabric softener.
This raises the mixture level above the tubes in the drawer
fabric softener cavity allowing the mixture to flow into the
tub. Like the detergent channel, the flow of the incoming
water is more than the holes can dispense. The excess
water backs up into the channel across the rear of the
dispenser and flows into the tub.

Drain Pump:

The drain pump is mounted to the bottom plate of the
washer behind the access panel. It operates on 120 VAC
and is controlled by the control board and pressure
switch. The pump out specifications of the drain pump
vary from 13 G.P.M with a 2 foot standpipe height to 8
G.P.M. with a 8 foot standpipe height. NOTE: If the
standpipe exceeds 8 feet, the pump will not evacuate the
tub.
56