Diagnostic Test - Electrolux GOOD Service Manual

Diagnostic Test:

The diagnostic test is performed by using the Program
Knob. To START THE TEST:
•
On non-digital display models, turn the
Program Knob to start position, Drain/Spin.
•
On digital display models, turn the Program
Knob to start position, Drain/Spin.
•
Press Pause/Cancel to turn off LEDs.
•
Within 5 seconds, press and hold the Option and
Pause/Cancel buttons until LEDs start
sequentially chasing, then release buttons.
1. All the LEDs will sequentially light. Pressing a
button below a light cluster will light all the LEDs in
that cluster at one time to confirm functionality.
2. Turn the program knob (1) click clockwise from the
start position. The hot water solenoid will activate
and hot water should enter through the detergent
compartment.
3. Turn the program knob (2) clicks from the start
position. The bleach water solenoid will activate and
cold water should enter through the bleach
compartment.
4. Turn the program knob (3) clicks from the start
position. The bleach and the wash water solenoids
will activate and cold water should enter through the
softener compartment.
5. Turn the program knob (4) clicks from the start
position. The door lock solenoid will activate.
6. Turn the program knob (5) clicks from the start
position. The door lock solenoid will deactivate and
the loading door can be opened.
7. Turn the program knob (6) clicks from the start
position. The washer will fill and tumble.
8. Turn the program knob (7) clicks from the start
position. The washer will fill and spin (leakage test).
9. Turn the program knob (8) clicks from the start
position. The drain pump and door lock solenoid will
activate and the washer will operate in high spin.
SAFETY WARNING: If power is removed during this
test, the door can be opened. To prevent injury, DO
NOT put your hands inside when the tub is rotating
10. Turn the program knob (9) clicks from the start
position. The control will signal the last error code.
See Section F, Troubleshooting, for details for
properly identifying the error code on non-digital
display models.
Exiting Diagnostic Mode
There are two options for exiting the Diagnostic Test mode
and returning the washer to normal operation:
a) Unplug the power cord, wait 5-8 seconds, then
reconnect the power cord OR
b) Turn the program knob clockwise 2 or 3 clicks after
the Start Position. Press Options and Pause/Cancel
buttons together for a few seconds until wash cycle
LEDs appear.
If a situation arises where you cannot exit the
Diagnostic mode as described above and the bank
of 5 LED's on the right end remain ON regardless of
Program Knob position, a combination of pushed
buttons caused the control to enter a special factory
test mode. Disconnect power to reset the control to
return washer to normal operation is this occurs.
To clear latest stored error code:
Place the control into Diagnostic test Mode.
•
Turn the program knob clockwise 9 clicks from the
Start Position. The control will signal the last error
code.
•
Press and hold the Options and Pause/Cancel
buttons for 3 seconds. The code will be cleared.
•
Exit Diagnostic Mode to return the washer to normal
operation.
10