Drain/Spin; Rinse/Spin; Cycle Settings; Wash/Rinse Water Temperature - Electrolux GOOD Service Manual

Drain/Spin

Use the Drain/Spin cycle as a follow-up to a No Spin
selection or anytime you want to drain water from the
washer and spin out the load. Select the spin speed
appropriate to the load.

Rinse/Spin

Select Rinse Spin for loads that need a cold water rinse
or to add fabric softener that may have been omitted in a
regular cycle. Add the fabric softener to the dispenser
chamber if desired. Select the spin speed appropriate
for the load.

Cycle Settings

Turn the TEMP knob and press SPIN until the desired
wash and rinse water temperatures and final spin speed
are selected. If the water temperature combination is
not appropriate for that cycle, the status lights will blink
and the signal will beep 3 times. Settings cannot be
changed after the cycle starts unless you cause the
program first. Adjustments to the cycle will automatically
be remembered each time that cycle is used.
Wash / Rinse Water Temperatures
Select the wash and rinse water temperatures appropri-
ate for each load.
• Hot/Cold for heavily soiled, white/colorfast cotton and
perm press loads.
• Warm/Cold for normally soiled, white/colorfast,
cotton and perm press loads.
• Cold/Cold for lightly soiled, non-colorfast items, knits,
delicates and hand washables.
• Warm/Warm for washable woolens.

Final Spin Speed

The suitable final spin speed for each cycle will auto-
matically be displayed. The speeds will vary from cycle
to cycle. For example, High Speed in the Normal cycle
is much faster than High Speed in the Handwash cycle.
To change the final spin speed, press SPIN until the
indicator for the desired selection is lighted. If a spin
speed is not recommended for a cycle, it will not be
displayed.
• Increasing spin speed will extract more water and
decrease drying time.
• Decreasing spin speed will reduce wrinkling.
• Use NO SPIN to omit the final spin at the end of the
cycle. The load will be very wet. Remove items from
wash drum to drip dry or select DRAIN / SPIN to
remove excess water at a more convenient time.

Water Level

There is no need to select a water level. The washer
automatically adjusts the water level to the type and
size of wash load.

Cycle Options

To select Heavy Soil/Stain, Extra Spin, Extra Rinse or
Cycle Signal, press OPTIONS until the light indicates
the desired option. Then press SELECT to add that option
to the cycle. To delete an indi-cated option, press
SELECT again. To provide the best care for your laundry
items, all options are not available with every cycle.
Heavy Soil / Stain
Use this option to add approximately 2 minutes of wash
time for very soiled or stained loads.

Extra Rinse

Use this option when additional rinsing is desired to
remove excess dirt and detergent. It is recommended
for heavily soiled loads or if household members have
sensitive skin. Extra Rinse occurs before the final rinse
when the liquid fabric softner is dispensed.

Extra Spin

Use this option to add several additional minutes to the
final spin at the selected speed. This will improve water
extraction and decrease drying time.

Cycle Signal

A signal will sound at the end of the cycle when the
cycle signal is selected.

Washer Features

Delay Start

Press the Delay Start to select a wash time convenient
to your schedule or during off peak energy hours. The
start of the cycle can be delayed for 8 hours.
Control

(Control Lock)

To avoid having someone accidentally start or stop the
washer, press OPTIONS and SELECT at the same time
until the Control (Control Lock) indicator is lighted.
To unlock the controls, press OPTIONS and SELECT
again.

Status Lights

The following will be displayed during the cycle:
• Door Lock
• Wash
• Rinse
• Final Spin
• Control (Control Lock)
30