Installation
13 Before connection, carefully clean the optical connectors on both fiber and module according to the
procedures in
14 Open the receiver or transmitter module fiber connector cover. Carefully slide the fiber connector into the
module connector until it clicks.
15 Repeat steps 12 and 13 for each receiver and transmitter module.
16 Splice fiber pigtail of optical fiber input cable to your splice enclosure.
17 Continue to
RF Cable Installation
The node can accept up to four RF cables. These cables carry forward path RF signal outputs and reverse path
RF signal inputs. The RF cables also supply the 45 to 90 V AC power input. Power can also be supplied
through the 2 Ports (3 and 6) which do not support RF signals.
Trimming the Center Conductor
The node requires pin-type connectors for all RF connections.
Standard pin connectors, with pins extending 1.5 in. to 1.6 in. (3.8 cm to 4.064 cm) from connector shoulder,
require no trimming. You must trim longer pins before inserting them into the housing.
Trimming Using the Integrated Cradle
To trim long pins using the integrated cradle, follow these steps.
1 Place the connector on the cradle as shown in the following illustration.
Care and Cleaning of Optical Connectors, on page
RF Cable Installation, on page
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide
42.
27.
RF Cable Installation
27