Cisco Gs7000 Super High Output Intelligent Node Installation And Operation Guide - Cisco GS7000 Installation And Operation Manual

Install Fiber Optic Cable
Warning
Laser light hazard. The laser light source on this product emits invisible laser radiation. Avoid direct
exposure. Never look into the end of an optical fiber or connector. Failure to observe this warning can
result in eye damage or blindness.
• Do not apply power to this product if the fiber is unmated or unterminated.
• Do not stare into an unmated fiber or at any mirror-like surface that could reflect light that is emitted
from an unterminated fiber.
• Do not view an activated fiber with optical instruments.
1 The first step depends on whether the fiber optic cable is factory installed or not.
IF...
fiber optic cable is factory installed
fiber optic cable is not installed
2 Select the right or left fiber connection port for use and remove its sealing plug.
3 Push in the two release tabs at the top of the fiber tray and swivel the top of the fiber tray up and back to
allow a clear view of the fiber routing channel below.

Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide

24
THEN...
splice fiber pigtail of optical fiber input cable to
your splice enclosure and continue to RF Cable
Installation.
go to step 2.
Installation