Amplifier Output Linear Tilt Chart - Cisco GS7000 Installation And Operation Manual

General Information
Module
Power Supply
Fiber Management
Tray and Track
Optical Interface
Board

Amplifier Output Linear Tilt Chart

The following chart can be used to determine the operating level at a particular frequency considering the
operating linear tilt.
Description
The node power supply module has multiple output voltages of +24.5, +8.5, -6.0, and
+5.5 V DC. A second power supply can be installed in the node for redundancy or
load sharing.
The node can be set up in the following powering configurations:
• two power supplies powered by different AC sources
• two power supplies using the same AC source
• a single supply using a single AC source
The fiber management system secures and protects the optical fiber inside the node
housing.
The Optical Interface Board (OIB) provides all interconnections between the modules
in the housing lid to the RF amplifier module in the housing base. Each module in the
lid plugs directly into the OIB through a connector header or row of sockets depending
on the module type. A forward path electronic controlled attenuator is provided on
the OIB for the setup of the Remote PHY device in the housing lid. A separate reverse
path electronic controlled attenuator is also provided on the OIB for the setup of the
Remote PHY device.
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide
Amplifier Output Linear Tilt Chart
5