Electric Shock Hazard; Equipment Placement; Product Ratings - Cisco GS7000 Installation And Operation Manual

Preface

Electric Shock Hazard

This equipment meets applicable safety standards.
Warning
To reduce risk of electric shock, perform only the instructions that are included in the operating instructions.
Refer all servicing to qualified service personnel only.
Electric shock can cause personal injury or even death. Avoid direct contact with dangerous voltages at all
times.
Know the following safety warnings and guidelines:
• Only qualified service personnel are allowed to perform equipment installation or replacement.
• Only qualified service personnel are allowed to remove chassis covers and access any of the components

Equipment Placement

Warning
Avoid personal injury and damage to this equipment. An unstable mounting surface may cause this
equipment to fall.
To protect against equipment damage or injury to personnel, comply with the following:
• Install this equipment in a restricted access location (access restricted to service personnel).
• Make sure the mounting surface or rack is stable and can support the size and weight of this equipment.

Product Ratings

• Electrical Ratings: quasi-square or sinusoidal wave 45 – 90 V, 50 – 60 Hz, max. pass-through current
• Ambient temperature range outside the node must be maintained between -40°C and +60°C (-40°F to
• Storage temperature range of the EDR must be maintained between -40°C to +85°C (-40°F to 185°F).
• Humidity range must be maintained between 5% to 95% non-condensing before installation of the EDR
• Max. altitude: <2000 m.
• Protection Grade: IP68.
inside the chassis.
15 A, max. surge current 25 A, internal power supply max. 185 W.
140°F).
Digital Return module(s).
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide
Electric Shock Hazard
ix