Advertisement
Supertop
®
for Truck Installation Instructions
Mount Tailgate Brackets to Rear Belt Rails
Locate the Right Tailgate Bracket and the Right Rear Belt Rail in the parts kit.
Place the Right Tailgate Bracket over the rear stud on the Belt Rail. This is
located 1-1/8" from the end of the rail. Orient the Bracket so that the bracket tab
points away from the channel on the Belt Rail. Use a 1/4-20 Cap Nut to secure
the bracket to the rail.
Repeat with the Left Tailgate Bracket and Rear Belt Rail.
1/4-20 Cap Nut
1-1/8"
Assemble Front Bow Mount
Brackets and Front Belt Rails
Locate the Right Front Belt Rail and place the Right
Bow Mount Bracket on top of it. Secure the bracket
to the rail with two (2) 1/4-20 Cap Nuts.
Repeat this with the Left Side Bow Mount Bracket
and Front Belt Rail.
1/4-20 Cap Nuts
Front Belt Rail
Rev. C 0811
Right Rear Belt Rail
Right Tailgate Bracket
Assemble Rear Bow Mount
Brackets and Rear Belt Rails
Slide a 5/16" Flat Washer over a 5/16" x 3/4" Clevis
Pin and insert it through the pivot hole on each Rear
Bow Mount Bracket from the outside.
Locate the Right Front and Rear Belt Rails. Place
the ends of the rails against each other. Place a Rear
Bow Mount Bracket on top of the Belt Rails. Secure
the bracket to the rail with two (2) 1/4-20 Cap Nuts.
Repeat this with the other Rear Bow Mount Bracket
and Belt Rails.
5/16" Flat
Washer
Bow
5/16" x 3/4"
Mount
Clevis Pin
Bracket
Front Belt
Rail
1/4-20 Cap Nuts
Assemble Bow Mounts Brackets
Locate the Bow Mount Brackets in the parts kit. Slide a 5/16" Flat Washer
over a 5/16" x 3/4" Clevis Pin. Insert the pin through the rear pivot hole on the
Bow Mount Bracket from the outside.
Slide a 1/4" Fender Washer over a 1/4" x 1-1/2" Clevis Pin and insert the pin
through the front slot of the Bow Mount Bracket from the outside.
Repeat this with both Bow Mount Brackets.
1/4" x 1-1/2"
Clevis Pin
Rear Pivot
Hole
5/16" Flat Washer
5/16" x 3/4" Clevis Pin
Measure and cut a piece of Foam Tape that will fi t
the full length of the bottom of the Belt Rail Assem-
bly. Peel the backing off the tape a little at a time
and press the tape fi rmly into place on the Belt
Rail Assembly. Trim the tape to match the contour
of the Tailgate Bracket.
Repeat this with both Belt Rail Assemblies.
Peel Backing
off a little at
a time
Rear Belt
Rear Bow
Rail
Mount Bracket
Bow Mount Bracket
Front Slot
1/4" Fender Washer
Install Foam Tape
Foam Tape
Rear Belt Rail
76315 pg. 3
Tailgate
Bracket
Advertisement
