Advertisement
Supertop
®
for Truck Installation Instructions
Install Rear Bow Assembly
Locate the two (2) Elastic Garters in the parts kit.
Slide a garter over each half of the Rear Bow from
the center so that the Garters will hang above the
rear window opening.
Slide the two (2) halves of the Rear Bow into the
remaining Bow Couplers. Slide the legs of the Rear
Bow Assembly over the 5/16" x 3/4" Clevis Pins on
the Rear Bow Mount Bracket and secure them with
a 5/16" Flat Washer and a Hitch Pin Clip on each
side of the vehicle. Put the remaining 5/16" Flat
Washer and Hitch Pin Clip on the Clevis Pin on the
front Bow Mount Bracket.
5/16" Flat
Washer
Front Bow
Assembly
Hitch
Pin Clip
Rev. C 0811
Rear Bow
Assembly
Install Adhesive Hook
Use a 50% Water/Alcohol Solution to clean the top
of the front wall of the truck bed. Locate the Adhe-
sive Hook Strip in the parts kit. Peel backing tape
off the hook strip 1"-2" at a time and press the hook
fi rmly onto the top of the front wall. The adhesive on
the hook strip requires 72 hours to cure completely.
Clean Area and install
Adhesive Hook Strip
Cut Web Strap Reinforcement
Place the top fabric on a safe, clean cutting surface.
Locate the two (2) wide patches in the seal below
the window on the front panel of the top. Use a util-
ity knife to cut a slit through all the layers following
the indent in the seal.
Front Window
Cut slit in
reinforcement
Install Buckle Straps
Locate the two (2) 32" Buckle Straps in the parts
kit. Thread the end of each strap through the
slits from the vinyl (outside) side of the top. Pull
the straps through the slits until the back of the
buckle is against the slit.
Pull Strap
Through
76315 pg. 5
Advertisement
