Table of Contents
Advertisement
Quick Links
Installation Instructions
Supertop
www.Bestop.com
- We're here to help! Visit our web site and click on
INSTALLATION TIME
3 Hours
TOOLS
1/8", 5/32",
7/32" and 3/8"
10'
®
SKILL LEVEL
3 - Moderately Diffi cult
#20, #40 and
#45
Vehicle Application
• Jeep CJ7
1976 – 1986
Hard Door Models
Part Number: 51599
"Ask a
Question". Click here for more
• Jeep Wrangler/YJ
1986 – 1995
Hard Door Models
Part Number: 51599
Jeep Accessories by Bestop.
Advertisement
Table of Contents
Related Manuals for Bestop Supertop
Summary of Contents for Bestop Supertop
-
Page 1: Installation Instructions
Part Number: 51599 Part Number: 51599 www.Bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”. Click here for more Jeep Accessories by Bestop. INSTALLATION TIME SKILL LEVEL 3 Hours 3 - Moderately Diffi cult TOOLS 1/8", 5/32",... - Page 2 Supertop ® – Installation Instructions Parts List and Top Fabric Qty - 1 #8 x 1/2" Pan Head Washer Hardware Identifi cation Quarter Window, Right Qty - 1 Screw - Black, Qty - 13, Part Quarter Window, Left Qty - 1 Number 200.48...
- Page 3 Supertop. Using parts shield Brackets. If present remove the outboard other than those provided in your Supertop kit can sun visor fasteners on both sides of the windshield result in personal injury and/or damage to the vehicle frame.
- Page 4 Supertop ® – Installation Instructions Reinstall the bolts that Under most circumstances, the wind- secure the Horizontal shield of the Wrangler will not require Sport Bars to the wind- any adjustment. If your Wrangler windshield should shield with a torque of 17.0 ft. lbs. each. If you do not...
- Page 5 ® Supertop – Installation Instructions A loose Windshield Re- When drilling in the top tainer may allow the top edge of the vehicle body, to disengage from the check underneath for windshield, causing damage to the top and possible wiring for the rear lights. Pull the wiring out of the injury to the occupants of the vehicle.
- Page 6 ® Supertop – Installation Instructions Install Vertical Retainer When drilling in the top edge of the vehicle body, Mounts check underneath for Install the Vertical Retainer Mounts on top of the wiring for the rear lights. Pull the wiring out of the Side Belt Rails, just behind the door openings.
- Page 7 ® Supertop – Installation Instructions Install Bow Assembly Lay the bow halves on top of the body with the holes in the Bow Mounts over the third and fourth holes in the Side Belt Rails. It is important that the white packaging tape remain on the bow assemblies until the forward bolt is tightened on both sides.
- Page 8 ® Supertop – Installation Instructions Windshield Install Bow Assembly Bracket Horizontal Release the small metal rods from the plastic clips on both sides of the vehicle. Turn Bailhead Lift the Top (Front) Bow and start the male end Stud 1/4 turn clockwise so pin of the Bottom (Rear) Bow into the female end.
- Page 9 ® Supertop – Installation Instructions Secure Rear Corners Install Top on Vehicle Insert the black plastic strips at rear corners of top Locate the top and orient it on the vehicle. Drape into Corner Belt Rails. There is a plastic reinforce-...
- Page 10 ® Supertop – Installation Instructions Raise the Rear Bow Secure Bottom of Side Curtain Slide the Rear Bow up on the Front Bow and insert Slip the plastic strip on the bottom of the side cur- the small bent tab into one of the four holes in the tain into the side retainer.
- Page 11 ® Supertop – Installation Instructions Install Rear Curtain Retainer Secure Front of Side Curtain Wrap fabric fl ap on the front of the side curtain Open the tailgate. Orient the Rear Curtain Retainer around the Vertical Rod (not the front bow) and with the rubber bulb facing down, in order to form a fasten the hook and loop strips to each other.
- Page 12 ® Supertop – Installation Instructions Now that your soft top is fully installed there are some fi nal Metal Door adjust- ments that may need to be made to give you the best weather seal possible. If any of these ad-...
- Page 13 ® Supertop – Installation Instructions When operating the vehicle without the Side Folding the Top Down Curtains, the Rear Curtain should be rolled up for proper ventilation. Open the zippers at the rear of the Side Curtains. Pull the plastic strip on the bottom of the Side Curtains out of the Belt Rails.
-
Page 14: Limited Warranty
Care and Maintenance of your Bestop Product Your Bestop product is made of the fi nest materials available. To keep it looking new and for the maximum possible wear, it will need periodic cleaning and maintenance. Fabric: The fabric should be washed often using soap, warm water and a soft bristle brush. Rinse with clear water to remove all traces of soap or use Bestop-recommended Bestop Cleaner and Bestop Protectant.