Advertisement
Supertop
®
for Truck Installation Instructions
Install Belt Rail Assemblies
Lay the Belt Rail Assemblies on top of the truck bed
rail with the tab on the Tailgate Bracket toward the
center of the vehicle. The front of the rail should be
fl ush with the forward edge of the front wall of the
truck box.
Measure the distance between the inside edges of
the right and left Belt Rail Assemblies at the front
and rear. Place them so that they are 63-1/2" at both
places and are centered and square on the bed.
Measurement between
Rails should be 63-1/2"
Rev. C 0811
Align Flush
with Front
Wall of Box
Belt Rail
Install Belt Rail Assemblies
Assembly
Locate the Clamps in
the parts kit. Use three
clamps to secure each
Belt Rail Assembly to
the vehicle. Place a
Clamp as close to each
end of the Belt Rail as
possible. Place the third
Clamp as close to the
center as possible. Fully
tighten the bolt on each
Clamp. Repeat this for
both Belt Rail Assem-
blies.
Slide a Bow Tie Down Strap onto each of the Front
Bow Halves. Slide the ends of each bow into a Bow
Coupler to join the two halves together.
Place a 1/4" Fender Washer over the 1/4" x 1-1/2"
Clevis Pins installed in the Bow Mounts. Slide the
legs of the Front Bow Assembly over the Clevis Pins
and secure them with 1/4" Flat Washer and a Hitch
Pin Clip on each side of the vehicle.
Belt Rail
Assembly
Front Bow
Assembly
Clamps
Rear
Assemble Front Bow
Bow Coupler
Front Bow Halves
Bow Tie Down
Straps
Install Front Bow
Hitch Pin
Clip
Bow Tie
Down Strap
1/4" Fender
Washer
1/4" Flat
Washer
76315 pg. 4
Advertisement
