Table of Contents
Advertisement
GLARE SHIELD INSTALLATION
The 15 Hex Bar IP comes with an attachable glare shield. The glare shield can easily be installed by
following the directions below. If you have any questions regarding installation, please contact ADJ
customer support.
1. Locate the three (3) screw holes located on either side of the unit.
2. Line up the three (3) glare shield thumb screws with the three (3) thumb screw holes located on
either side of the unit. Screw the thumb screws in and tighten. DO NOT overtighten.
FILTER INSTALLATION
The 15 Hex Bar IP comes with an optional frost/diffuser filter. The filter can easily be installed by
following the directions below. If you have any questions regarding installation, please contact ADJ
customer support.
Locate the filter slot door located at either end of the unit. Pull and hold the slot door down and gen-
tly slide the frost/diffuser filter in. Make sure the filter is all the way inside before releasing the slot
door to close.
28
Advertisement
Table of Contents
