Advertisement
Perform the Initial Configuration
You must perform the initial configuration of the switch through the console port. Before you begin, set the following parameter
values from the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
Ensure the PTX10002-60C is powered on.
1.
Use any terminal emulation program, such as HyperTerminal, to connect to the device console. The CLI displays a login prompt.
2.
Log in as
. There is no password. If the software booted before you connected to the console port, you might need to press
3.
root
the Enter key for the prompt to appear.
login: root
Start the CLI.
4.
root@% cli
Enter configuration mode.
5.
root> configure
Add a password to the root administration user account.
6.
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
(Optional) Configure the name of the router. If the name includes spaces, enclose the name in quotation marks (" ").
7.
[edit]
root@# set system host-name host-name
Configure the default gateway.
8.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the management interface.
9.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
Although the CLI permits you to configure two management Ethernet interfaces within the same
subnet, only one interface is usable and supported.
Copyright © 2018, Juniper Networks, Inc.
PTX10002-60C Quick Start Guide
7
Advertisement
