Advertisement
PTX10002-60C Quick Start Guide
Figure 2: Removing the Screws Holding the Cover
Align the holes in the mounting rail with the holes on one side of the chassis. (see
5.
Figure 3: Attaching Mounting Rails to the PTX10002-60C Chassis
31
Attach the mounting rail to the PTX10002-60C by using 11 flat-head M4x6-mm Phillips mounting screws. Tighten the screws.
6.
Repeat Step
5
and Step
7.
Either use a mechanical lift or have two people grasp both sides of the switch, lift it, and position it in the rack so that the front
8.
bracket is aligned with the rack holes.
Have another person secure the front of the PTX10002-60C to the rack by using eight mounting screws (and cage nuts and
9.
washers if your rack requires them). Tighten the screws.
Continue to support the PTX10002-60C while sliding the rear-mounting blades into the channel of the side-mounting rails
10.
and securing the blades to the rack (see
them) to attach the blade to the rack. Tighten the screws.
Figure 4: Attaching the PTX10002-60C to the Rack
Ensure that the PTX10002-60C chassis is level by verifying that all the screws on the front of the rack are aligned with the
11.
screws at the back of the rack.
(Optional) Attach a grounding cable to earth ground and then attach it to the chassis grounding point.
12.
4
6
on the opposite side of the PTX10002-60C.
Figure
4). Use eight mounting screws (and cage nuts and washers if your rack requires
Figure
3).
Copyright © 2018, Juniper Networks, Inc.
Advertisement
