Advertisement
Connect the AC PTX10002-60C to Power
Before you connect the PTX10002-60C to power:
Read General Electrical Safety Guidelines and Warnings and Action to Take After an Electrical Accident in the PTX10002-60C
Packet Transport Router Hardware Guide.
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage (see Prevention of
Electrostatic Discharge Damage in the PTX10002-60C Packet Transport Router Hardware Guide).
Ensure that you have connected the PTX10002-60C chassis to earth ground.
NOTE:
To meet safety and electromagnetic interference (EMI) requirements and to ensure proper operation, you
must connect the chassis to earth ground before you connect it to power. For installations that require a separate
grounding conductor to the chassis, use the protective earthing terminal on the PTX10002-60C chassis to connect
to the earth ground (see Connect the PTX10002-60C to Power in the PTX10002-60C Packet Transport Router
Hardware Guide).
CAUTION:
Before you connect power to the PTX10002-60C, a licensed electrician must attach a cable lug to the
grounding and power cables that you supply. A cable with an incorrectly attached lug can damage the router (for
example, by causing a short circuit).
Install the power supply in the chassis following the instructions in Maintaining the PTX10002-60C Power Supplies in the
PTX10002-60C Packet Transport Router Hardware Guide.
To connect the PTX10002-60C to AC power:
NOTE:
Refer to the PTX10002-60C Packet Transport Router Hardware Guide for instructions on how to connect the
PTX10002-60C to DC power.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to an approved site ESD
1.
grounding point.
Ensure that the power supplies are fully inserted in the chassis and the latches are secure.
2.
If the AC power source outlet has a power switch, set it to the off
3.
Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate (see
4.
Copyright © 2018, Juniper Networks, Inc.
position.
(O)
PTX10002-60C Quick Start Guide
Figure
5).
5
Advertisement
