Dynojet Power Commander III Manual page 4

6 Attach the supplied wire tap to the brown wire with a
white tracer. It is recommended to use dialectric grease
before crimping the wire tap down.
Wire tap
7 Attach the grey wire from the PCIII to the wire tap. It is
recommended to use dialectric grease at this connection.
Fig.D
Fig.E
Grey wire
from PCIII
4
8 Attach the ground wire from the PCIII to the negative
side of the battery.
Ground wire from PCIII
9 Install the PCIII under the tool kit. If you do not use
the tool kit use the supplied velcro to attach the PCIII.
(Fig. G).
Fig.F
Fig.G
5