Table of Contents
Advertisement
Tail light unit: C: Remove the bulb
Fig. 87
holder, D: Remove the bulbs.
Complete operations only in the sequence
given.
Removing the tail light units
›››
1.
Open the rear lid
page
Carefully remove the cover
2.
›››
Fig. 86
A.
Pull the release
in the connector
3
›››
3.
rection of the arrow
Fig. 86
er in the vehicle tool kit.
Press position
and remove the connector
4
4.
›››
Fig. 86
B.
86
5.
Unscrew the wing nut
Remove the tail light from the bodywork by careful-
6.
ly pulling backwards.
Disassemble the tail light unit and place it on a
7.
flat, clean surface.
To change the bulb
Unlock the bulb holder locking tab (arrow)
›››
8.
tail light.
Replace the faulty bulb by a new identical bulb
9.
›››
Place the lamp holder in the tail light unit. The at-
10.
tachment tabs (arrow) should audibly click into
place
Assembling the tail light units
Carefully insert the tail light unit into the opening
11.
in the bodywork.
Support the tail light with one hand in the assem-
12.
bly position and securely screw the wing nut with
the other
101.
Ensure that the tail light unit has been correctly
towards the lever
1
13.
fitted and is firmly secured.
Insert the connector
in the di-
2
14.
press the lock
B. Use the screwdriv-
site direction to the arrow
15.
Insert the cover. The cover should lock into place.
2
16.
Close the rear lid
Emergencies
›››
Fig. 86
B.
5
Fig. 87
C and remove the bulb holder from the
Fig. 87
D.
›››
Fig. 87
C.
›››
Fig. 86
B.
5
into the bulb holder and
2
on the connector in the oppo-
3
›››
Fig. 86
B.
›››
page
101.
Changing the number plate light
On the rear bumper: Remove the
Fig. 88
number plate light.
Number plate light: Remove the bulb
Fig. 89
holder.
Complete operations only in the sequence giv-
en:
With one hand, press on the number plate light
1.
from left to right and remove it from the bumper
›››
Fig.
88.
Advertisement
Table of Contents
