Table of Contents
Advertisement
WARNING
If the road is not well-lit and the vehicle is
not clearly visible to other drivers, there is a
risk of accident.
WARNING
Failure to replace bulbs correctly may cause
serious accidents.
Before carrying out any work in the engine
●
compartment please read and observe the
›››
warnings
page
186. In any vehicle, the en-
gine compartment is a hazardous area and
could cause severe injury.
The bulbs H4, HB4 and H7 are pressurised
●
and might explode on changing them.
Replacing the bulbs in the headlights
There is no need to remove the headlight to
replace bulbs.
Fuses and bulbs
Only replace the bulbs concerned when
●
they have cooled.
●
Never replace bulbs alone if you are not fa-
miliar with the operations necessary. If you
are not sure about procedures then visit a
specialised workshop to carry out the neces-
sary work.
●
Never touch the bulb glass directly. Finger-
prints will be evaporated by the heat of the
operating bulb thus "fogging" up the reflec-
tor.
●
The headlamp frameworks in the engine
compartment and the tail lamps contain
sharp elements. Always protect your hands
when changing bulbs.
»
CAUTION
●
After changing a bulb, if the rubber covers
are not replaced correctly on the headlamp
framework, the electrical installation may be
damaged, especially if water is allowed to en-
ter.
Remove the ignition key before working on
●
the electric system. Otherwise, a short circuit
could occur.
●
Switch off the lights and the parking light
before changing a bulb.
Take good care to avoid damaging any com-
●
ponents.
In the engine compartment: Rear view of
Fig. 83
the front left headlight with rubber cover:
ped beam and main beam headlights,
lights and daytime driving lights and
nal
dip-
A
side
B
turn sig-
C
83
Advertisement
Table of Contents
