Table of Contents
Advertisement
Always adapt your speed and the distance
●
to the vehicles ahead in line with visibility,
weather conditions, the condition of the road
and the traffic situation.
The City Safety Assist function does not re-
●
act to people, animals or vehicles that cross
or move in the opposite direction in the same
lane.
●
If after switching on the City Safety Assist
function the vehicle begins to move, slow the
vehicle with the foot brake.
CAUTION
If you suspect that the City Safety Assist ra-
dar feature is damaged, switch it off. This will
avoid additional damage.
●
Any repair of the radar sensor requires spe-
cialist knowledge. SEAT recommends taking
your car in for technical service.
Note
●
If the City Safety Assist function activates a
brake, the brake pedal range is reduced. This
makes the brake pedal seem "harder".
Automatic brake intervention by the City
●
Safety Assist function can be cancelled by
pressing the clutch pedal, the accelerator
pedal or by a corrective intervention.
●
During automatic braking by the City Safety
Assist function you may hear unusual noises.
This is normal and is produced in the brake
system.
154
Operation
Warning and control lamp
The City Safety Assist function is switched on
every time the ignition is switched on. No
special indication is produced.
If the City Safety Assist function is switched
off or on, or if there is an error in the system,
it will be shown by a control lamp on the in-
strument panel display.
It lights up
The City Safety Assist
The control lamp turns off after
function has been
about 5 seconds.
switched on manual-
ly using the button
›››
Fig.
150.
Flashes
Fast: The City Safety
Assist system func-
Control lamp turns off automati-
tion brakes automat-
cally.
ically or has braked
automatically.
If the vehicle is stopped, switch
off the engine and switch it on
again. If necessary, inspect the
Slow: City Safety As-
radar sensor (dirt, frost)
sist function is not
Radar sensor on page
currently available.
still does not function, refer to a
Specialised workshop to have
the system inspected.
Within the operating
area of 5-30 km/h
(3-19 mph): The City
Safety Assist func-
tion has been
switched off manual-
ly using the button
›››
Fig.
150.
Several warning and control lamps should
light up for a few seconds when the ignition
is switched on, signalling that the function is
being verified. They will switch off after a few
seconds.
WARNING
If the warning lamps are ignored, the vehicle
may stall in traffic, or may cause accidents
and severe injuries.
Never ignore the warning lamps.
●
Stop the vehicle safely as soon as possible.
●
CAUTION
Failure to heed the warning lamps when they
appear may result in faults in the vehicle.
›››
in
155. If it
Flashes
Switch on the City Safety Assist
function manually using the
›››
button
Fig.
150.
Advertisement
Table of Contents
