Table of Contents
Advertisement
Do not consult the messages on the instru-
●
ment panel screen when driving.
Note
On the screen of the SEAT Portable System
›››
(supplied by SEAT)
functions of the vehicle can be seen.
Management of indications on the
display
Windscreen wiper lever: control but-
Fig. 32
tons.
Calling up options
●
Switch the ignition on.
●
If a message or vehicle symbol is dis-
played, press
OK/RESET
●
Press the top or bottom part of the rocker
›››
switch
Fig. 32
until the desired option
B
appears.
26
Multifunction display (MFI)
The multifunction display (MFI) has two auto-
matic memories: 1 - Partial memory and 2 -
Total memory. The selected memory will be
shown in the lower right-hand corner of the
page 166
other
display.
With the ignition switched on, and memory 1 or
2 displayed, briefly press
one memory to another.
Trip memo-
ry (for a
1
single jour-
ney).
Total mem-
2
ory (for all
journeys).
›››
(
Fig. 32
).
A
The essentials
to change from
OK
The memory stores the values for the
journey and the consumption from
the moment the ignition is switched
on until it is switched off again.
If the journey is broken for more than
2 hours, the memory is automatically
erased. If the journey is continued in
less than 2 hours after the ignition is
switched off, the new data is added to
the data already stored in the memo-
ry.
The memory stores the values of any
number of journeys, until it counts a
total of 19 hours and 59 minutes of
driving, or 1999.9 km or miles of driv-
ing, depending on the type of instru-
ment panel fitted. On reaching either
of these limits, the memory is auto-
matically erased and starts to count
from 0 again.
Possible displays
Menu
Function
Time
Current time in hours (h) and minutes
(min).
Journey du-
This indicates the hours (h) and mi-
ration
nutes (min) since the ignition was
switched on.
Current
The current fuel consumption display
operates throughout the journey, in
fuel con-
l/100 km; with the engine running
sumption
and the vehicle stopped, in l/hour.
After turning on the ignition, average
Average
fuel consumption in litres/100 km will
fuel con-
sumption
be displayed after travelling about
100 metres. Otherwise horizontal
lines are displayed. The value shown
is updated approximately every 5 sec-
onds.
Operating
Approximate distance in km that can
still be travelled with the fuel remain-
range
ing in the tank, assuming the same
style of driving is maintained. This is
calculated using the current fuel con-
sumption.
Distance
Distance travelled, after ignition is
covered
switched on, in km.
Average
The average speed will be shown after
speed
a distance of about 100 metres has
been travelled. Otherwise horizontal
lines are displayed. The value shown
is updated approximately every 5 sec-
onds.
Advertisement
Table of Contents
