Connecting The Indicator; Mounting The Indicator; Setting Up The Pillar Version Scale - Adam Equipment CPWplus 6 Manual

3.2

CONNECTING THE INDICATOR

The indicator comes attached to a bracket with the help of two thumb screws and is
separately packed. Remove from the packaging and attach the cable to the
connector at the side of the base. Tighten the ferrule to secure the cable.
3.3

MOUNTING THE INDICATOR

The indicator attached to the bracket can be mounted in the following 3 ways. To
adjust the angle of the indicator, use the two thumb screws on the side of the
bracket that connects the indicator.
1. Place it on the work bench- Simply place the indicator attached to the
bracket on the work bench at an angle.
2. Attach it to the base of the scale- There are two thumb screws on
the base (opposite to the Power input and RS-232 ports). Remove
them from the base and use them to attach the bracket to the base.
3. Mount it on the wall- Use two suitable screws (not supplied) to fix the
bracket to the wall.
3.4

SETTING UP THE PILLAR VERSION SCALE

The CPWplus standard series come without the Pillar. The Pillar can be added at a
later stage, to convert the scale into the Pillar version.
Indicator
Thumb screw
Bracket
Pillar
Socket
Base
© Adam Equipment Company 2006
•
The Pillar
Remove it from the packaging.
•
Connect the cable attached to the Pillar to
the connector inside the plastic socket
situated at the base. Tighten the ferrule to
secure the cable.
•
Place the Pillar inside the plastic socket in
the upright position and secure it with the M6
screws.
•
Attach the bracket with the indicator to the
top of the Pillar using normal screws.
Connect the cable to the connector as
before.
•
To adjust the angle of the indicator, use the
two thumb screws on the side of the bracket
that connects the indicator.
5
comes separately packed.