Manually Entering New Network Settings; H4100 And H4300 Series; H5400 Series With Microsoft Pocket Pc 2002 - HP iPAQ H4100 series User Manual

4. In the same pop-up box under "This network connects me to:" tap the Internet button (if the
network connects to the Internet without using proxy settings) or the Work button (if the
network uses proxy settings). If doubt exists about the whether the network uses proxy
settings, then contact the system administrator. For additional information, see the section in
this document entitled "Setting up the proxy server."
5. If the display prompts for a Network key (WEP), then enter the key and tap Connect. (If there
are any questions about the Network key, then contact the network administrator.)

Manually entering new network settings

h4100 and h4300 series

To manually add settings to a wireless network, perform the following steps:
1.
Turn on the WLAN on.
2. Tap the Connections icon (
tap Network Card.
3. On the "Configure Wireless Networks" screen, tap the Wireless tab at the bottom.
4. Still on the "Configure Wireless Networks" screen, in the "Wireless networks:" box, tap
"Add New Settings..."
5. Tap the General tab at the bottom; in the Network name box, type the network name (SSID).
NOTE: If a network was detected in Step 2, then the SSID is automatically entered and cannot
be changed.
6.
In the "Connects to:" box, tap to select either "The Internet" (no proxy server is used), or "Work"
(a proxy server is used).
7. If the network is an ad-hoc connection, then tap the "This is a device-to-computer (ad-hoc)
connection" box.
8. If network authentication is required, then on the Configure Wireless Network screen, tap the
Authentication tab. If in doubt about possible required authentication information, then
contact the system administrator.
9. Select the type of network authentication to be used:
A. For data encryption, tap the "Data encryption (WEP Enabled)" checkbox.
B. To use Shared Key authentication, tap the" Network Authentication (Shared mode)"
checkbox. Enter the Network Key in the "Network Key:" box.
C. If a network key is provided by the network automatically, then tap the "The Key is
provided for me automatically" checkbox.
D. If IEEE 802.1x is supported by the network environment, then tap the "Enable
network access using IEEE 802.1x" checkbox and then the appropriate
authentication protocol (TLS, PEAP). 802.1x provides an increased level of security. If
unsure whether the network environment supports the 802.1x protocol, then contact
the network administrator.

h5400 series with Microsoft Pocket PC 2002

To manually add settings to a wireless network on the h5400 series with Microsoft Pocket PC 2002,
perform the following steps:
1. On the Start screen, tap Start, Settings, tap the "Connections" tab at the bottom of the screen,
and then tap the "Connections" icon.
The Wireless LAN and HP iPAQ Pocket PCs
or ) at the top, tap Settings, tap the Advanced tab, and then
16