Working With Hp-Supported Wireless Authentication Protocols; H4100 And H4300 Series; H5400 Series With Microsoft Pocket Pc 2002 - HP iPAQ H4100 series User Manual

4. On the Connections screen, under "My Work Network," tap "Edit my proxy server," and
then the Proxy Settings tab.
5. Tap the "This network connects to the Internet" and "This network uses a proxy server to
connect to the Internet" checkboxes.
6. In the Proxy server box, enter the proxy server name received from the network administrator.
Tap "OK" if the port number or proxy server type settings do not require changes, and skip
step number seven.
7. If port number or proxy server type settings must be changed, then tap "Advanced" and
make the necessary settings changes. Tap "OK".
Working with HP-supported wireless authentication
protocols
Instructions for configuring an HP iPAQ Pocket PC with a high security authentication protocol vary
between product series and the selected protocol. Other affecting issues are ROM releases, operating
systems, and protocol-specific requirements, to name a few.
The following instructions, arranged by HP iPAQ Pocket PC series, are intended as a roadmap to help
the user get started. Actual implementation may require additional steps, consultation with ISPs,
network administrators, and/or implementation direction from third party software companies such as
Cisco Systems. Assistance may also be obtained from the HP website (
Systems website (
www.cisco.com

h4100 and h4300 series

Perform the following steps to begin setting up an HP-supported authentication protocol on an HP
iPAQ Pocket PC h4100 or h4300 series handheld device:
1. Turn on the WLAN.
A. Tap Start, "iPAQ wireless", and then tap the "WLAN" button (if the WLAN is on,
then the WLAN icon will be green; if the WLAN is off, then the WLAN icon will be
orange).
B. Tap the "X" to return to the Start screen.
2. At the Start screen, tap Settings and then the Connections tab.
3. Tap the Connections icon, the Advanced tab, and then Network Card.
4. On the "Configure Wireless Networks" screen, in the "Wireless network" box, highlight the
appropriate default setting or create a new setting.
5. On the Configure Wireless Network screen, select the appropriate network and tap the
Authentication tab.
6. On the Configure Network Authentication screen:
A. Check "Data encryption (WEP enabled)"
B. Un-check "Network Authentication (Shared mode)"
C. Check "The key is provided for me automatically" or enter the appropriate Network
key
D. Check "Enable network access using IEEE 802.1x"
E. Tap the desired protocol in the "EAP type:" drop-down box

h5400 series with Microsoft Pocket PC 2002

Perform the following steps to set up an HP-supported authentication protocol on an HP iPAQ Pocket
PC h5400 series with Microsoft Pocket PC 2002 handheld device:
1. Turn on the WLAN.
The Wireless LAN and HP iPAQ Pocket PCs
).
) and the Cisco
www.hp.com
42