Deleting Wireless Network Settings; Configuring 802.1X Authentication Settings - HP iPAQ rx4200 - Mobile Media Companion User Manual

The WLAN IP Address is shown here, as well as other detailed information about your current WLAN
connection.

Deleting Wireless Network Settings

You can delete network settings you manually entered. However, if a network was automatically
detected, your HP iPAQ may continue to automatically detect the network.
To delete existing or available wireless network settings:
1. Tap Start > Today > iPAQ Wireless.
2. Tap the WLAN icon to turn WLAN on.
3. Tap the WLAN tab > View WLAN Networks > Wireless tab.
4. In the Configure Wireless Networks box, tap and hold the desired network settings.
5. Tap Remove Settings.

Configuring 802.1x Authentication Settings

Before performing these steps, determine if authentication information is needed by contacting your
network administrator.
1. To manually enter information, tap Start > Today > iPAQ Wireless > WLAN tab > View WLAN
Networks > Wireless tab.
2. In Configure Wireless Networks, select the desired network.
3. For increased security, tap 802.1X tab > Use IEEE 802.1x network access control. Then select
the appropriate EAP type.
NOTE
EAP types may be obtained from your network administrator or a third party.
16 Chapter 2 Connections
The only two EAP types supported are PEAP and Smart Card or Certificate. Additional
ENWW