Table of Contents
Advertisement
4-3-2. TARGET-BRT : LOW, MIDDLE, HIGH
Selects the brightness value that you set the target area in MODE.
4-3-3. WEIGHT : LOW, MIDDLE, HIGH
Selects the WDR value that you set the target area in MODE.
i
If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR and
3D-NR functions are disabled in all video outputs. It should be considered when
installer adjusts the video with installation monitor via CVBS video signal.
5. DAY & NIGHT
DAY/NIGHT is used to control the setting during day-time and night-time operation.
Select the mode according to the light condition and the camera types.
MENU V1. XX
1. LENS
2. ZOOM/FOCUS
3. EXPOSURE
4. BACKLIGHT
5. DAY&NIGHT
6. COLOR
7. 3D-NR
8. IMAGE
9. MOTION
A. SYSTEM
B. EXIT
5-1. EXTERN
DAY or NIGHT is determined by the built-in light photo sensor.
Camera with IR LED must be set to EXTERNAL.
5-1-1. SMART IR
SMART IR can be set to reduce the saturation by the strong IR illumination in
the night in any menu of EXTERN, AUTO and B/W(NIGHT). Set to ON, SMART IR
is enabled and ANTI-SAT. level is controlled.
5-1-2. ANTI-SAT. (Available only with the SMART IR is ON)
Sets the anti saturation level 0~20. Setting high level avoids the saturation strongly
but the corners will be darker accordingly.
5-1-3. DELAY
D→N DELAY is time in second while camera maintains its status before Day to
Night switches. DELAY can avoid the unwanted/frivolous switching by a short
term lights such as light from the passing car. Sets delay term low, middle or high.
18
DC
OFF
EXTERN
MIDDLE
OFF
SAVE
5. DAY&NIGHT
SMART IR
ON
ANTI-SAT.
10
llllllllllllllllllllll
DELAY
MIDDLE
IR LED CTL
AUTO
RETURN
Advertisement
Table of Contents
