Solving Problems - Gastroback Design Mincer Plus Operating Instructions Manual

Solving Problems
If any problems occur during operation, you will find solutions in the following table. Addi-
tionally, you can contact your vendor.
Problem
The motor does not work,
the indicators are dark.
The motor does not work,
the buttons are illumina-
ted.
The reverse operation
does not work. The ON/
OFF button is illuminated
blue.
The motor works too slow-
ly.
Juice drips from the cutter
housing.
Possible Cause
The appliance is not live.
The power switch is switched
OFF.
The circuit breaker is activa-
ted.
The overheat protection swit-
ched off the appliance.
The cutter housing is blocked.
You cannot start reverse ope-
ration, while forward operati-
on is switched on.
The cutter housing is blocked.
You push down the pusher too
violently.
Too hard parts are still in the
foods.
The food is too hard.
The food is too watery.
42
Solution
Insert the power plug in the
power outlet.
Switch on the power switch.
Press the red button at the bot-
tom of the appliance.
Let the motor cool down (See:
›Overheat protection‹).
Switch to reverse operation
for a moment (See: ›Clearing
a blocking – reverse operati-
on‹)
Switch off the ON/OFF but-
ton. This button must be illumi-
nated white to activate rever-
se operation. Try again.
Switch to reverse operation
for a moment (See: ›Clearing
a blocking – reverse operati-
on‹).
Decrease the pressure
pushing.
Remove any hard parts before
processing your foods.
Only process foods that have
a similar consistency as meat.
Cook hard vegetables before
processing. Cut the food in
smaller pieces.
Do not process food that is too
juicy. Dab dry before proces-
sing.
of