Cisco NCS 6000 Series Configuration Manual page 484

Use Wildcards For Routing Policy Sets
RP/0/RP0/CPU0:router(config)# rd-set rd_set_demo2
RP/0/RP0/CPU0:router(config-rd)# 20.0.0.1/7:99,
RP/0/RP0/CPU0:router(config-rd)# 4784:199
RP/0/RP0/CPU0:router(config-rd)# end-set
2. Configure a route policy with wildcards to refer to the route distinguisher set.
RP/0/RP0/CPU0:router(config)# route-policy use_rd_set
RP/0/RP0/CPU0:router(config-rpl)# if rd in rd-set* then set local-preference 100
RP/0/RP0/CPU0:router(config-rpl-if)# elseif rd in(10.0.0.2:888, 10.0.0.2:999)then set
local-preference 300
RP/0/RP0/CPU0:router(config-rpl-elseif)# endif
RP/0/RP0/CPU0:router(config-rpl)# end-policy
3. Commit your configuration.
RP/0/RP0/CPU0:router(config)# commit
4. (Optional) Verify your configuration.
RP/0/RP0/CPU0:router(config)# show configuration
...
Building configuration...
!! IOS XR Configuration 0.0.0
!
rd-set rd_set_demo
10.0.0.1/8:77,
10.0.0.2:888,
65000:777
end-set
!
!
rd-set rd_set_demo2
20.0.0.1/7:99,
4784:199
end-set
!
route-policy use_rd_set
if rd in rd-set* then
set local-preference 100
elseif rd in (10.0.0.2:888, 10.0.0.2:999) then
set local-preference 300
endif
end-policy
!
end
This completes the configuration of routing policy with wildcards for route distinguisher sets. For more
information on route distinguisher sets, see
Use Wildcards for OSPF Area Sets
Use the following example to configure a routing policy with wildcards for OSPF area sets.
1. Configure the OSPF area set in the global configuration mode.
RP/0/RP0/CPU0:router(config)# ospf-area-set ospf_area_set_demo1
RP/0/RP0/CPU0:router(config-ospf-area)# 10.0.0.1,
RP/0/RP0/CPU0:router(config-ospf-area)# 3553
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
462
rd-set, on page 391.
Implementing Routing Policy