Configuring Multi-area Adjacency
Command or Action
RP/0/RP0/CPU0:router(config-ospfv3)#spf
prefix-priority route-policy ospf3-spf-priority
Step 6
commit
Step 7
show rpl route-policy route-policy name detail
Example:
RP/0/RP0/CPU0:router#show rpl route-policy
ospf-spf-priority detail
prefix-set ospf-critical-prefixes
66.0.0.0/16
end-set
!
route-policy ospf-spf-priority
if destination in ospf-critical-prefixes then
set spf-priority critical
endif
end-policy
!
Configuring Multi-area Adjacency
This task explains how to create multiple areas on an OSPF primary interface.
Before you begin
Note
You can configure multi-area adjacency on any interface where only two OSF speakers are attached. In the
case of native broadcast networks, the interface must be configured as an OPSF point-to-point type using the
network point-to-point command to enable the interface for a multi-area adjacency.
SUMMARY STEPS
1. configure
2. router ospf process-name
3. area area-id
4. interface type interface-path-id
5. area area-id
6. multi-area-interface type interface-path-id
7. commit
DETAILED STEPS
Command or Action
Step 1
configure
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
312
Purpose
Displays the set SPF prefix priority.
Purpose
Implementing OSPF