Cisco NCS 6000 Series Configuration Manual page 81

Implementing BGP
5. commit
DETAILED STEPS
Command or Action
Step 1 configure
Step 2 router bgp as-number
Example:
RP/0/RP0/CPU0:router(config)# router bgp 120
Step 3 address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RP0/CPU0:router(config-bgp)# address-family
ipv4 unicast
Step 4 Do one of the following:
• redistribute connected [ metric metric-value ] [
route-policy route-policy-name ]
• redistribute eigrp process-id [ match { external
| internal }] [ metric metric-value ] [ route-policy
route-policy-name ]
• redistribute isis process-id [ level { 1 |
1-inter-area | 2 }] [ metric metric-value ] [
route-policy route-policy-name ]
• redistribute ospf process-id [ match { external [
1 | 2 ] | internal | nssa-external [ 1 | 2 ]]} [ metric
metric-value ] [ route-policy route-policy-name ]
• redistribute ospfv3 process-id [ match { external
[ 1 | 2 ] | internal | nssa-external [ 1 | 2 ]]} [
metric metric-value ] [ route-policy
route-policy-name ]
• redistribute rip [ metric metric-value ] [
route-policy route-policy-name ]
• redistribute static [ metric metric-value ] [
route-policy route-policy-name ]
Example:
RP/0/RP0/CPU0:router(config-bgp-af)# redistribute
ospf 110
Step 5 commit
• redistribute rip [ metric metric-value ] [ route-policy route-policy-name ]
• redistribute static [ metric metric-value ] [ route-policy route-policy-name ]
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Redistributing Prefixes into Multiprotocol BGP
Purpose
Specifies the autonomous system number and enters the
BGP configuration mode, allowing you to configure the
BGP routing process.
Specifies either the IPv4 or IPv6 address family and enters
address family configuration submode.
To see a list of all the possible keywords and arguments for
this command, use the CLI help (?).
Causes routes from the specified instance to be redistributed
into BGP.
59