Creating A Virtual Link With Md5 Authentication To Area 0 For Ospf - Cisco NCS 6000 Series Configuration Manual

Creating a Virtual Link with MD5 Authentication to Area 0 for OSPF

Command or Action
RP/0/RP0/CPU0:router(config-ospf)# timers lsa
refresh 1800
Step 6
timers lsa min-arrival seconds
Example:
RP/0/RP0/CPU0:router(config-ospf)# timers lsa
min-arrival 2
Step 7
timers lsa group-pacing seconds
Example:
RP/0/
/CPU0:router(config-ospf)# timers lsa group-pacing
1000
Step 8
commit
Creating a Virtual Link with MD5 Authentication to Area 0 for OSPF
This task explains how to create a virtual link to your backbone (area 0) and apply MD5 authentication. You
must perform the steps described on both ABRs, one at each end of the virtual link. To understand virtual
links, see
Note
After you explicitly configure area parameter values, they are inherited by all interfaces bound to that
area—unless you override the values and configure them explicitly for the interface. An example is provided
in Virtual Link Configured with MD5 Authentication for OSPF Version 2: Example, on page
Before you begin
The following prerequisites must be met before creating a virtual link with MD5 authentication to area 0:
• You must have the router ID of the neighbor router at the opposite end of the link to configure the local
• For a virtual link to be successful, you need a stable router ID at each end of the virtual link. You do not
• Before configuring your virtual link for OSPF Version 2, you must decide whether to configure plain
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
292
Virtual Link and Transit Area for OSPF, on page 268
router. You can execute the show ospf or show ospfv3 command on the remote router to get its router
ID.
want them to be subject to change, which could happen if they are assigned by default. (See
Process and Router ID, on page 263
we recommend that you perform one of the following tasks before configuring a virtual link:
• Use the router-id command to set the router ID. This strategy is preferable.
• Configure a loopback interface so that the router has a stable router ID.
text authentication, MD5 authentication, or no authentication (which is the default). Your decision
determines whether you need to perform additional tasks related to authentication.
Purpose
• The default is 1800 seconds for both OSPF and
OSPFv3.
Limits the frequency that new processes of any particular
OSPF Version 2 LSA can be accepted during flooding.
• The default is 1 second.
Changes the interval at which OSPF link-state LSAs are
collected into a group for flooding.
• The default is 240 seconds.
.
for an explanation of how the router ID is determined.) Therefore,
Implementing OSPF
339.
OSPF