Quick Reference Table - Supermicro SuperServer E100-9S User Manual

SuperServer E100-9S/-9S-E/-9S-L User's Manual

Quick Reference Table

Jumper Description
JLCDPWR1 LVDS Panel VCC power source selection
JPF1 FORCE POWER ON
JPME2 Manufacturing Mode
TPM Enable/Disable Header
JPT1
(X11SSN-L does not support TPM)
Connector
AUDIO FP
BT1
DP++
FAN1
I-SATA1
JCOM1: COM1/COM2
JCOM2: COM3/COM4
JD1
JF1
JGP1
JHDMI1
JMD1
JMP1
JPH1
JPW1
JPW2
JSMBUS1
LAN1, LAN2
LVDS1
SRW1 - SRW4
USB0/1
USB2/3
USB4/5
USB6
USB7
(* Default Setting)
Description
Front Panel Audio Header (Mic-In/Headphone-Out)
Battery Connector
(To Clear CMOS, remove the battery, short pins 1-2 for more than 10 seconds and
install the battery.)
DisplayPort
System Fan Header
SATA 3.0 Port
COM Headers
(JCOM1 supports two RS232/RS422/RS485, JCOM2 supports two RS232)
Speaker Header (Pins 1-4)
Front Control Panel Header (Power/HDD LED, Reset, Power button)
8-bit General Purpose I/O Header
Back Panel HDMI 2.0 Port
M.2 Slot B-KEY 2280 (PCIe x2 Gen3, one USB 2.0, one SATA 3.0)ww
Full Size Mini PCI-E Slot with mSATA (one PCIe x1 Gen3, one USB 2.0, one SATA 3.0)
SATA Power Connector (for one HDD systewwwwwwwwwwwaaawm)
4-pin 12V R/A Type Power Connector (for X11SSN-H/E/L and X11SSN-H/E/L-WOHS)
4-pin 12V Vertical Type Power Connector (for X11SSN-H/E/L-VDC)
System Management Bus Header
LAN (RJ45) Ports
Dual Channel 48-bit LVDS Connector
M.2 and Mini PCI-E Mounting Holes
USB 2.0 x 2 Header
USB 2.0 x 2 Header
Back Panel USB 3.0 Ports
USB 3.1 Type C Port
USB 3.0 OTG Header (one USB 3.0, one USB 2.0)
12
Jumper Setting
Pin 1-3* (3.3V)
Pin 3-5 (5V)
Pin 3-4 (12V)
Pin 1-2* (FORCE POWER ON)
Pin 2-3 (POWER BUTTON ON)
Pin 1-2* (Normal)
Pin 2-3 (Manufacturing)
Pin 1-2* (Enable)
Pin 2-3 (Disable)