Supermicro SuperServer E100-9S User Manual page 44

SuperServer E100-9S/-9S-E/-9S-L User's Manual
COM2 Port Mode
Use this feature to select the COM port mode. The options are RS232 Mode, RS422 Mode,
and RS485 Mode.

Serial Port 3 Configuration
Serial Port
Select Enabled to enable the onboard serial port specified by the user. The options are
Disabled and Enabled
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of a
serial port specified by the user.
Change Settings
This feature specifies the base I/O port address and the Interrupt Request address of Serial
Port 3. Select Auto to allow the BIOS to automatically assign the base I/O and IRQ address
to a serial port specified. The options are Auto, (IO=3E8h; IRQ=7), (IO=3E8h; IRQ=3, 4,
5, 6, 7, 9, 10, 11, 12), (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12), (IO=2F0h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12), and (IO=2E0h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).

Serial Port 4 Configuration
Serial Port
Select Enabled to enable the onboard serial port specified by the user. The options are
Disabled and Enabled
Device Settings
This feature displays the base I/O port address and the Interrupt Request address of a
serial port specified by the user.
Change Settings
This feature specifies the base I/O port address and the Interrupt Request address of Serial
Port 4. Select Auto to allow the BIOS to automatically assign the base I/O and IRQ address
to a serial port specified. The options are Auto, (IO=3E8h; IRQ=7), (IO=3E8h; IRQ=3, 4,
5, 6, 7, 9, 10, 11, 12), (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12), (IO=2F0h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12), and (IO=2E0h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).
PCH-FW Configuration
The following firmware information will display:
•
ME Firmware Version
•
ME Firmware Mode
44