Silicon Laboratories Si4700 User Manual page 10

AN232
Figure 6. Configuration Screen to Select Device
Figure 7. Configuration Screen Successfully Initializing Device
TIP 1. If the Si4700/01 Development GUI doesn't find your device, try unplugging and plugging in the USB cable
again, pushing the "reset" button on the baseboard, connecting the power again, or re-launching the software.
TIP 2. It's normal for the GUI to display "Searching for Devices..." continuously even after initializing the selected
device. This allows additional devices to be quickly identified.
TIP 3. Be sure the USBXpress device driver is installed. See " Appendix—Installing the USBXpress Device."
10 Rev. 0.2