Settings Menu Parameters - Kemppi X3 Operating Manual

4.2.5 Settings menu parameters

In Settings menu you can enable or disable welding parameters and adjust their
values.
Parameter
CrE Creep start
Pre gas
PrE
Pre gas Pre gas
Pos Post gas
Hard ignition
Ign
Makes the arc ignition stronger by increasing welding
voltage at the start of the weld.
HSt Hot stop
Enhances the end of the weld in certain applications
by delaying the arc extinction and raising the welding
voltage at the end of welding. Especially useful in tack
welding.
Burn back time
BUr
Time that torch will be live after welding has stopped
to prevent filler wire from sticking to the work piece.
(-01 = Use defaults from welding program.
LOC Panel Lock
Locks the setup panel and prevents welding
parameters from being changed.
'LOC' flashes on the screen on attempt to change
parameters. Setting is remembered on the next
startup.
FAC Factory reset
Resets the user interface and special settings to
factory defaults on menu exit.
Values
1 = On / 0 = Off
1 = On / 0 = Off
1 = On / 0 = Off
1 = On / 0 = Off
1 = On / 0 = Off
1 = On / 0 = Off
Integer (ms):
-01...999
1 = enabled with
code 769
0 =disabled with
code 769
1 = On / 0 = Off
13
© Kemppi Oy 2018
To enable or disable welding parameters
1. Open Settings menu by pressing
simultaneously
.
Gas select and 2T/4T buttons to navigate to the desired parameter.
2. Use
Crater fill button to toggle the the state of the parameter (On or Off )
3. Press
4. Exit the menu and save the changes by pressing
simultaneously.
To set values for Burn back time or Panel lock code
1. Open Settings menu by pressing
simultaneously.
2. Use Gas select and 2T/4T buttons to navigate to
3. Press Crater fill button to activate a single digit so that it starts to blink.
4. Use Gas select and 2T/4T buttons to increase and decrease the value of the
digit.
5. Press Crater fill to activate another digit.
6. Press Crater fill and Gas test
changes.
To use carbon arc gouging
Press Crater fill and 2T/4T to enter the gouging
+
mode.
Adjust the voltage with Gas select
+
buttons.
Activate another digit by pressing
button.
Exit gouging mode by pressing
+
2T/4T simultaneously.
Output terminals are live in carbon arc gouging mode.
X3 MIG Welder
Crater fill and Gas test buttons
Crater fill and Gas test buttons
Crater fill and Gas test buttons
BUr or LOC menu item.
simultaneously to exit the menu and save the
and 2T/4T
Crater fill
Crater fill and
.
1814