Configuring the Module,
8.
Under Controls, double-click the parameter you want to configure.
Result: The Change Value dialog box displays. The graphic below shows the
dialog box for the Equalization parameter.
9.
The Equalization control is used to ensure that the output signal is flat across
all channels.
10.
Click Execute.
Result: The new value displays next to the parameter.
11.
Under Controls, double-click the parameter you want to configure.
Result: The Change Value dialog box displays. The graphic below shows the
dialog box for the Operational Mode parameter.
78-4006323-01 Rev C
Continued
Operation Using LCI
4-23