Cisco Prisma II Installation And Operation Manual page 68

Forward and reverse headend driver amplifiers
Hide thumbs Also See for Prisma II:
Table of Contents

Advertisement

SNMP Configuration Capability,
11.
Repeat steps 6 through 10 for each IP Setup parameter that you need to enter.
12.
Restart the ICIM.
Important: IP Setup parameters do not take effect until the ICIM is restarted.
Restarting the ICIM
Follow these steps to restart the ICIM.
1.
Unscrew the captive screw near the top right-hand corner of the ICIM.
2.
Unlock the top and bottom ejector levers near the left-hand side of the ICIM.
Pull the ejector levers out and away from the front panel to disconnect the
3.
ICIM from the chassis backplane connector.
4.
Pull the ICIM at least 1.5 inches (3.81 cm) out from the front of the chassis to
ensure that it is fully separated from the chassis backplane connector.
5.
Reinsert the ICIM into the chassis until the ejector levers insert into their
respective slots in the chassis.
6.
Push the ejector levers in and flat against the ICIM front panel to reconnect
the ICIM to the backplane connector until the ejector levers lock in place.
7.
Screw in the captive screw to secure the ICIM in the chassis.
78-4006323-01 Rev C
Continued
Operation Using ICIM
3-35

Advertisement

Table of Contents
loading

Table of Contents