Cisco Prisma II Installation And Operation Manual page 24

Site Requirements,
Power Requirements
Prisma II modules receive their electrical power from the Prisma II Chassis. The
module may be installed with the chassis powered-up.
Space Requirements
This module is a single-width module. It is usually installed in slots 5 through 16.
Slots 1 through 4 are usually reserved for the power supplies. Slots 15 and 16 are
reserved for the Intelligent Communications Interface Module (ICIM), if installed. If
an ICIM is not installed, this module could be installed in these slots. Slot 2 and slot
4 are reserved for an internal power supply if installed. If an internal power supply
is not installed here, this module could be installed in these slots.
Chassis Style
The Prisma II Chassis may be configured with front or rear connectors depending on
the system you have purchased. Power, RF input/output, and other connectors may
be located on either the front or rear of the Prisma II Chassis. Connections to the
chassis serve the same function and are made in the same manner regardless of the
location of the connectors or chassis configuration.
2-4
Continued
Installation 78-4006323-01 Rev C