Configuring the Module,
2.
Under Controls, double-click the parameter you want to configure.
Result: The Change Value dialog box displays. The graphic below shows the
dialog box for the Enable parameter.
3.
Enable control turns the amplifier On or Off.
4.
Click Execute.
Result: The new value displays next to the parameter.
5.
Under Controls, double-click the parameter you want to configure.
Result: The Change Value dialog box displays. The graphic below shows the
dialog box for the Attenuation parameter.
The Attenuation control allows setting output of the amplifier to the level
6.
required by the device to which the signal is being routed.
7.
Click Execute.
Result: The new value displays next to the parameter.
4-22
Continued
Operation Using LCI
78-4006323-01 Rev C