Starting Lci - Cisco Prisma II Installation And Operation Manual

Starting LCI

Introduction
When LCI is started, it polls the module(s) located in the chassis your computer is
attached to. For each module it finds, LCI does the following:
• Represents the module in the module tree of the main LCI window
• Makes the polling information available so you can check and configure various
parameters
Important: Your computer must be connected to the chassis before you start LCI.
For instructions, refer to Connecting Your Computer to the Chassis earlier in this
chapter.

Starting LCI

To start the software, double-click the LCI icon on your Windows desktop.
Results:
• LCI polls the modules in the chassis
• The main LCI window displays
4-8 Operation Using LCI 78-4006323-01 Rev C