Accessing The Module Details Window - Cisco Prisma II Installation And Operation Manual

Accessing the Module Details Window

Introduction
Information about a module (its parameters, alarms and statuses) is located in the
Module Details window. The graphic below shows the Module Details window for
a Prisma II FHEDA.
Within LCI's module tree, you can access this window using one of the following
four methods:
• Double-click the chassis and select the module in the graphic that displays
• Right-click the chassis and select Open from the menu that displays
• Double-click the module
• Right-click the module and select Details from the menu that displays
Note: Although you can use the method that's most convenient for you, the
procedures throughout this chapter are described using the right-click module
technique.
For more information about the module tree, refer to LCI Module Tree Overview
earlier in this chapter.
78-4006323-01 Rev C Operation Using LCI 4-11