AccuLine CNQplus 1000RT User Manual page 8

Connecting one EBM in a rack form
1. Using the same method as assembling the UPS in a rack form, assemble
EBM into the rack-mounting on the top or bottom of the UPS.
2. Connect the earth line from UPS (port A ) to EBM (port B )
3. Take off the LCD box, and unscrew the internal screws.
4. Take off the front panel, and connect the battery terminal (A) from the UPS
to EBM terminal (B) shown as below. Users need to remove the small
gate(C) on side of the front panel to allow the outlet wire of the EBM to pass
through the gate and then reassemble front panel.
5. After installing the
UPS. Please make sure the load equipment is turned off before plugging all
loads into the UPS output receptacles
into the rack, the load can then be connected to the
B
A
B
A
C
7
Unscrew
Unscrew