Flashforge Finder User Manual page 61

on the build area. Click[Back]and double-click the Moveicon again, then click [On
the Platform] and [Center]to ensure the model be on the platform.
7-4
Note If you ve place your model in a right place, you can skip the step above.
(7-5) Click the[Print]icon on the top, you should make some setups for your print job.
7-5
Preview: If you check the [Preview]box, you can preview your model after slicing is
done.
60
Finder User Guide | www.flashforge.com 400-699-1063