Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
1. Off-hook and dial * or the last digit of the
dialed station number.
2. Await answer to announce the call.
3. Or, replace the handset and go on-hook.
To answer the call waiting/camp-on,
1. A SLT station is busy and camp-on tone is
heard.
2. Make hook-flash and dial 5 6 0.
3. Then the SLT station is connected to the
station which made call waiting/camp-on.
4. Make hook-flash and dial 5 6 0 again, then
the station is connected to the original station.
Admin Programming
n
Voice Over (PGM 113-BTN 6)
Operation
1. Voice over is also applied in SLT.
CO LINE QUEUING
Description
When a user of single line telephone receives a
busy signal during an attempt to access a CO
line, the user may request a call back (queue)
when the CO line is available. The station will
receive a call back when the busy CO line or a
CO line in the CO line group becomes available.
Operation
To activate queuing while receiving busy tone,
1. Press and release hook-switch.
2. Dial 5 5 6.
3. Confirmation tone is heard and then replace the
handset.
4. When the CO line becomes idle, callback ring
is received at the SLT. Lifting handset in the
SLT, CO dial tone is heard to make a call.
Admin Programming
n
CO Line Queuing (PGM 112-BTN 5)
Condition
1. A CO line may have any number of queues at
one time.
2. When the queued CO line becomes idle or a
CO line becomes available in the group, the
oldest queued station will receive signal.
3. A station can make only one CO line queuing
request at one time. If the station tries to
make another CO line queuing, the previous
one is canceled and the later one is available.
4. If the waiting station is busy and the queued
CO line is available, the available CO line will
be directed to the next station which is idle.
5. If the waiting station is idle, the queued CO
line will give signal to the station for 15
seconds. If the signal is not received at the
station, the queue is canceled and the next
station in the queue will receive signal.
CONFERENCE
Description
A single line telephone can initiate a 3-way
conference with any combination of CO line or
internal users.
Operation
To set up a conference from SLT,
1. Place the first call.
2. Press and release hook switch and intercom
dial tone will be heard. The existing call is
placed on exclusive hold and the recall timer
is activated.
3. Place
the
second
conference.
4. Press and release hook switch and you will
be connected to the first call.
5. Within 2 seconds, press hook switch to
establish a conference.
Condition
1. If you make hook-flash after 2 seconds,
brokers call will be initiated.
5-3
LDK-
SLT Features
call
and
announce
Advertisement
Table of Contents
