Table of Contents
Advertisement
Programming Manual for Digital Key Telephone System
300 & LDK-100
CALL FORWARD - UNCONDITIONAL
Description
A user forward all calls immediately to another
station or station group.
Operation
To activate Unconditional Call Forward,
1. Lift the Handset or press the [MON] button.
2. Press the [DND/FOR] button.
3. Dial Call Forward Code 1.
4. Dial station or group pilot number to receive
the calls.
5. Replace the handset and go on-hook.
To activate Call Forward to VMIB,
1. Lift the handset or press the [MON] button.
2. Press the [DND/FOR] button.
3. Dial Call Forward Code (1~4).
4. Dial VMIB selection code # to receive the call.
5. Replace the handset and go on-hook.
To deactivate Unconditional Call Forward,
1. In idle state;
Press [DND/FOR] button.
2. In off-hook state,
Press [DND/FOR] button and dial #.
Admin Programming
n
Call Forward (PGM 111-BTN 2)
Condition
1. Call Forward cannot be assigned to a station
which is in DND state.
2. Assigning Call Forward while CO line queue/
Message Wait/DND/Preselected Message is
activated,
the
previous
canceled and Call Forward will be assigned.
3. The intercom answer is 'To ne' mode in Call
Forward.
4. A station in the forward mode can make
outgoing calls (internal or external).
5. Call forward chain can be made but, a station
cannot forward to a station which is already a
member of the chain.
6. If the last member of the call forward chain is
in DND, the caller will hear DND tone for ICM
call.
7. Forwarded data is protected when the
8. If you attempt call forward to VMIB without
CALL WAITING/CAMP-ON
Description
When a user calls a busy station, busy tone is
heard and the user can give a signal to the busy
station. The busy station (off-hook or on
speakerphone) is notified of the call waiting by a
camp-on
[HOLD/SAVE] button.
Operation
To activate Call Wait while receiving intercom
busy tone,
Dial , the last digit of the busy station, press the
busy DSS flexible button, or flexible button
assigned as {CALL WAIT}.
To answer a Call Wait while receiving intercom
busy tone,
Press the [HOLD/SAVE] button, the active CO
line is placed on exclusive hold and the call
waiting is connected. By pressing [HOLD/SAVE]
button, you can talk two parties in turns.
Admin Programming
n
Condition
feature
will
be
1.
2.
3.
4.
5.
2-5
system power is off.
recording VMIB user greeting, warning tone
will be heard and cannot make call forward.
tone
and
flashing
Stop Camp -on Tone (PGM 112 – BTN 15)
To assign the {CALL WAIT} button at a
flexible button,
[TRANS/PGM] + Flex. BTN + [TRANS / PGM] +
8 5 + [HOLD/SAVE]
During a conference or paging, Call Waiting
is not activated.
Camp-on is not applied to a station which is
in DND.
The attendant can override a station using
Camp-on feature.
If the 'Stop Camp -on Tone' is set to 'ENABLE',
LDK-
Intercom Features
LED
of
the
Advertisement
Table of Contents
