Table of Contents
Advertisement
9. Install the new module into the cubicle:
•
Push the module back in and attach. Be careful not to break the fastening screws:
tighten the fastening screws of the module to 22 N·m (16.2 lbf.ft). Tighten the
fastening bolts of the DC output busbars to 70 N·m (51.6 lbf.ft).
•
Connect the module plug connectors and fiber optic connectors that you
disconnected earlier.
•
Remove the module pull-out ramp, attach the shrouds (if any) and close the
cabinet doors.
5
Maintenance 143
a
Advertisement
Table of Contents
