Table of Contents
Advertisement
2) Set crosspoints to register.
3) Enter a name for the matrix in the Salvo Name setting box.
4) Click Apply. A message box as shown below appears, and the matrix is successfully
registered.
Recalling Matrix
1) Select Salvo Mode, then select a salvo setting in the Salvo section at the bottom of the
screen. Salvo crosspoint settings that are different from the current crosspoints are
displayed in yellow as shown below on the left.
2) Click Load in the Salvo section to switch the crosspoints.
When switching crosspoints in Salvo mode, crosspoints cannot be changed arbitrarily.
IMPORTANT
47
Advertisement
Table of Contents
