Trinabess Power Box Installation Manual page 53

ID53 SpiCommLose
ID54 SciCommLose
ID55 RecoverRelayFail
OverTempFault_B
ID57
AT
OverTempFault_H
ID58
eatSink
OverTempFault_En
ID59
v
unrecoverHwAcO
ID65
CP
ID66 unrecoverBusOVP
BitEPSunrecoverBa
ID67 tOcP
unrecoverOCPInst
ID70
ant
unrecoverEEPROM
ID75
_W
unrecoverEEPROM
ID76
_R
unrecoverRelayFai
ID77
l
ID81 Over temperature
SPI communication is
fault
SCI communication is
fault
The relays fault
The PowerCube
temp is too high
The temperature
heat sink is too high
The environment temp is
too high
The grid current is too
high and has caused
unrecoverable
hardware fault
The bus voltage is too
high and has caused
unrecoverable fault
Unrecoverable fault of
the PowerCube
overcurrent in EPS mode
The grid current is too
high, and has caused
unrecoverable
Please check the circuit
with any ground fault.
The EEPROM
unrecoverable
The EEPROM
unrecoverable
Relay has happenned
permanent fault
Internal temperature is
too high.
2.0 ID57-ID59 Check whether
the air condition around
the equipment is good. Or
of
set the "max discharging
& charging current "a little
lower to check whether
the fault is rectified. If the
fault occurs
please contact technical
support.
ID65-ID77
faults of the POWER BOX,
turn OFF the "DC switch",
wait for 5 minutes, then
turn ON the "DC switch"
and turn ON the "AC
switch". Check whether
the fault is rectified. If no,
please contact technical.
2.0
fault.
is
is
1. Please make sure the
POWER BOX in installed in
frequently,
are internal