Trinabess Power Box Installation Manual page 52

ID18 HwADFaultDCI
ID19 HwADFaultVGrid
ID21 MChip_Fault
ID22 HwAuxPowerFault
ID25 LLCBusOVP
ID26 SwBusOVP
ID27 BatOCP
ID28 DciOCP
ID29 SwOCPInstant
ID30 BuckOCP
ID31 AcRmsOCP
ConsistentFault_V
ID49
Grid
ConsistentFault_F
ID50
Grid
ConsistentFault_D
ID51
CI
BatCommunicato
ID52
nFlag
The DCI sampling error
The grid voltage
sampling error
The master chip fault
The auxiliary voltage
error
LLCBus voltage is too
high
Bus voltage is too high
and has triggered
software protection
PowerCube 2.0 current
is too high
The DCI is too high
The grid current is too
high
Buck current is too high
The output current is too
high
The grid voltage
sampling
between the master
DSP and slave DSP is not
consistent
The grid frequency
sampling
between the master
DSP and slave DSP is not
consistent
The Dci sampling value
between the master
DSP and slave DSP is not
consistent
PowerCube
communication fault
If the
frequently, please contact
technical support.
ID28-ID55
faults of the POWER BOX,
turn OFF
switch", wait for 5 minutes,
then turn ON the "DC
switch" and turn ON the
"AC switch".
whether
rectified.
contact
value
support.
For ID52: Please check
and ensure
between Powerbox and
Powercube
value
correctly. Note that the
Ethernet
customized and not a
standard cable, refer to
Table 2. On how to make
the cable.
2.0
fault occurs
are internal
the "DC&AC
Check
the fault is
If no, please
technical
the cable
is wired
cable is